Xr20 Remote-Control Programming - Hiltron security XR Serie Manual Para El Usuario

XR500 - User's Manual
3.2 Remote control XR20 settings
Hold down the button
Set the System Code using XR20 buttons:
!
- Left Button (red):
- Right Button (green):
If the data entering is suspended for more than 30 seconds, the LED blinks for some
seconds, the Central Unit exits automatically from programming mode and the previous code
is unchanged.
In case of mistake, you can stop the data entering, holding down the 2 buttons for some
seconds: the LED blinks for some seconds and the programming is interrupted. In case of right
code, the LED flashes one time and the programming mode finishes.
In case of wrong code (all "0" or all "1") the LED blinks for some seconds and the Central
Unit exits from the programming mode without saving the code.
Holding down a button for a long time, the relative command is sent for 10 times, than the
XR500 wait for the button is released before to allow a new dispatch. This function allows to
prevent the unloading of the battery if a button stayed pressed.
42
s for some seconds, rel
to enter "1".
to enter "0".
ease them when the green LED is lit.
security
"1" "0"