sounds while battery is charging, please remove the charger from
battery, and the sound alarm will stop.
2.5 INSTRUCTIONS FOR USE: Pilot-12 Plus
A. Charging the battery
Plug the 90W battery charger (B) into the battery's CHARGE port.
Ensure that the other end of the charger is plugged in to the mains
power outlet. Please note: The battery can be charged regardless of
whether or not the battery is switched ON or OFF. If the battery is
charging properly, the four green charge indicator lights (3c) will
flash, and will light up solid green once it is fully charged.
B. Using with PAP Device as a portable battery
Please Note: To increase run time, please disconnect the heated
humidifier from the PAP device. When PAP device is connected
with the heated humidifier and is used with the battery, the battery
run time may be significantly decreased. Use DC OUT port to
connect the PAP device to the battery. First, select one of the Two
Connector Tips (D) that fits the PAP device being used, then connect
this tip to the Output Cable (C). Attach the end of the Output Cable
(C), with the connector tip (D), to the PAP device and plug the other
end of the Output Cable (C) into the "DC OUT" port on the battery.
Ensure that the battery is switched to "ON" position by using the
OFF/ON switch (2) on battery control panel.
16