Safety And General Information; Product Description - Omega Lift Equipment 10120 Manual Del Usuario

SAFETY AND GENERAL INFORMATION

Save these instructions. For your safety, read, understand, and follow the information provided with and on this
device before using. The owner and/or operator shall have an understanding of the device, its operating characteristics
and safety operating instructions before operating the equipment. The owner and/or operator shall be aware that use
and repair of this product may require special skills and knowledge. Instructions and safety information shall be read
to and discussed with the operator in the operator's native language, making sure that the operator comprehends
their contents, before use of this equipment is authorized. If any doubt exists as to the safe and proper use of this
device, remove from service immediately.
Inspect before each use. Do not use if abnormal conditions such as cracked welds, damaged, loose or missing
parts are noted. Any equipment that appears damaged in any way, is found to be worn, or operates abnormally shall
be removed from service until repaired. If the equipment has been or is suspected to have been subjected to an
abnormal load or shock, immediately discontinue use until inspected by a factory authorized repair facility (contact
distributor or manufacturer for list of authorized repair facilities). It is recommended that an annual inspection be
made by an authorized repair facility. Labels and Operator's Manuals are available from the manufacturer.

PRODUCT DESCRIPTION

Omega In-Line Bottle Jacks are designed to lift, not support, rated capacity loads consisting of one end of a vehicle.
Immediately after lifting, the load must be supported by an identical pair of appropriately rated jack stands.
!
WARNING: Never use hydraulic jack as a stand alone device. After lifting, immediately support the lifted load
with an identical pair of appropriately rated jack stands.
SPECIFICATIONS
Model Capacity
10120 12 Ton
10128
10200
10208
Oil Filler Plug/Screw
Release Valve
(not shown)
Base Size (L x W)
7" x 4-1/4"
12 Ton 7" x 4-1/4"
20 Ton 7-3/4" x 5"
20 Ton 7-3/4" x 5"
Saddle
Figure 1 - Typical In-Line Bottle Jack Nomenclature
Min. Height
9-1/2"
6"
9-1/2"
6-1/2"
Extension Screw
Handle Sleeve
2
Max. Height
18-5/8"
10-3/4"
18-5/8"
11-1/4"
Handle
Ext. Screw
3-1/8"
1-5/8"
3-1/8"
1-5/8"