Panasonic ES2219 Instrucciones De Operación página 6

With the outer foils in place, apply
r shaver
some hand soap onto the outer foils.
ugh 6)
Turn the shaver on and turn off after
rotective cap and ap-
few seconds.
her generously. For the
Next, press the outer foil frame re-
ove the shaver in back
lease buttons to remove the outer foil
ions, while keeping the
frame and rinse the inner blade/outer
t a right angle (90°) to
foils under running water or in a ba-
at the two trimmers and
sin.
together at the same
DO NOT USE BOILING WATER.
pop-up trimmer switch
Next, close the outer foil frame and
the pop-up trimmer to
dry it gently. After the shaving head
(see fig. 2).
is dry, place the protective cap.
ee fig. 3)
m up enough to stretch
Replacing shaving head
d shave back and forth.
Components
g. 4)
move the shaver from It is recommended that you replace
e. the outer foil at least once every year
g. 5) and the inner blade at least once
every two years to maintain your
move the shaver from
shaver's cutting performance.
side.
g. 6)
Replacing the outer foil
ended to use the pop-
Press the outer foil frame release but-
or proper shave.
tons to remove the outer foil frame
(see fig. 8).
selector
Then, squeeze the front and the back
side of the foil frame and lift up one
t action selector to
of the two knobs on the outer foil (see
aving mode:
fig. 9).
d range, or lock based
ng preference.
Inserting the new outer foil
Slip the foil into the frame and guide
the plastic edges onto the hooks in
the foil frame until it clicks into the
s and convenience, we
shaver.
that you clean your
Replacing the inner blade
ater and a liquid hand
(see fig. 10)
cleaning will keep your
Squeeze the outer foil frame release
d condition while pre-
buttons and lift the outer foil frame up-
or bacteria from devel-
ward to remove it. Remove the inner
aintain the cutting per-
blade by grasping it firmly at both
ends and pulling straight away from
8
the shaver. To insert the new inner
blade, hold the blade at both ends
and press downward until it snaps
into the shaver.
ATTENTION:
The product you have purchased
is powered by a nickel cadmium
battery which is recyclable. At the
end of its useful life, under vari-
ous state and local laws, it is ille-
gal to dispose of this battery into
your municipal waste stream.
Please call 1-800-8-BATTERY for
information on how to recycle this
battery.
How to remove the built-in
rechargeable battery
before disposal of shaver
The battery in this shaver is not in-
tended to be replaced by consumers.
However, the battery may be re-
placed at an authorized service
center. The procedure described be-
low is intended only for removal of the
rechargeable battery for the purpose
of proper disposal.
WARNING:
Do not attempt to replace the bat-
tery for the purpose of reusing the
shaver. This could result in the
risk of fire or electric shock.
1. Remove the back rubber panel (a)
and the front panel (b) with a flat
screwdriver. (see fig. 11)
2. Remove two screws (c). (see fig.
12)
3. Pull the housing (d) out of the end
cap. (see fig. 13)
4. Remove two screws (e) and pull
the battery frame (f). (see fig. 14)
5. Remove the battery (g) with a flat
screwdriver. (see fig. 15)
ATTENTION:
This laws of various states and
municipalities restrict disposal of
rechargeable batteries (and prod-
ucts from which such batteries
have not been removed) in ordi-
nary household waste. Please
comply with your local laws. If you
are not certain as to proper dis-
posal, please contact your local
sanitation department.
Caution
• Do not charge the shaver where the
temperature is below 0°C (32°F) or
above 40°C (104°F), where it will
be exposed to direct sunlight or a
heat source, or where there is a lot
of moisture.
• Use only the included shaver
charging stand RE7-12 to charge
the ES2219 shaver.
• The supply cord of the charging
stand cannot be replaced; if the
cord is damaged, the entire charger
should be discarded.
• Dry the shaver completely before
setting it in the charging stand.
• Keep the charging stand away from
water and handle it only with dry
hands. Do not use an extension
cord to connect the charging stand
9
to an outlet.
9