Memory Function; Care And Maintenance - Laica BM1001 Instrucciones Y Garantía

English
GB
values (see paragraph "CLASSIFICATION OF THE BLOOD PRESSURE VALUES"). After the
measurement, the device emits a short acoustic signal.
Automatic re-pressurisation
The starting pre-set pressure level is 191 mmHg.
If the pre-set pressure is insufficient in the preliminary reading phase or if the hand or wrist is
moved, the unit will start inflating again until 228 mmHg are reached.
Automatic re-pressurisation is repeated until a valid reading is taken. However this is not sign of
a fault with the appliance.
5) If you want to stop measuring for any reason, simply press the 0/I key and remove the cuff. The
unit switches off automatically if it is left idle for 1 minute, otherwise you can switch it off by
pressing the 0/I key.
Make sure the batteries are charged. Low or dead batteries decrease the efficiency
of the pump, which then cannot provide enough pressure in the preset time interval.
For this reason, ERR will appear. Replace the batteries.

MEMORY FUNCTION

This device can store up to 60 measurements.
After each measurement, the following values are stored automatically: diastolic, systolic, pulse,
date and time, memory number, reference segments for the classification of the blood pressure
values (see paragraph "CLASSIFICATION OF THE BLOOD PRESSURE VALUES") and the possible
presence of an irregular pulse (arrhythmias)
To call up the stored measurements, it is necessary to press the key M, on the display appears on
the left bottom corner the number of the stored measurements.
Each pressure of the key let the stored data scroll and on the left bottom corner of the display appears
the memory number. The number "60" corresponds to the oldest measurement, while the number "1"
indicates the most recent value. After 60 measurements, the oldest data are deleted automatically.
The stored data are displayed for about 2 minutes. After about 1 minute from the release of the key
WRIST BLOOD PRESSURE MONITOR
.
36
Instructions and guarantee
M, the device switches off; otherwise, it is possible to switch it off, by pressing the key O/I.
DELETING THE STORED DATA
To delete all stored data, it is necessary to keep the key M pressed till the display shows "- -"; as
soon as the key is released, the display shows "0 SYS 0 DIA 0 PULSE 00 mem."
Now, all stored data have been deleted.
Moreover, when the batteries are replaced, all measurements are deleted automatically.
INDICATORS
The following symbols may appear on the display:
EE : no measurement could be taken as the arm moved, incorrect position, other ....
see section entitled "CORRECT MEASURING METHOD".
: batteries finished. Replace batteries.
: Pulse frequency symbol.
M : progressive memory number assigned to each measurement
: indicator of irregular pulse
: reference segments for the classification of the blood pressure values

CARE AND MAINTENANCE

• This unit contains precision components.
Hence, care must be exercised to avoid exposing the unit to extreme changes in temperatures,
humidity, knocks, dust and direct sunlight. Do not drop or hit the unit.
• Clean the unit using a soft, dry cloth only.
English
37
GB