Choosing And Installing Attachments-Cutting Blades - Hamilton Beach Commercial HMI200 Manual De Operación

Choosing and Installing Attachments–Cutting Blades
wWARNING
Pinch and Cut Hazard
Make sure that the mixer is off and unplugged
before installing or removing attachments and
parts.
Blades are sharp! Use extreme care when
handling.
Failure to follow these instructions can result
in broken bones, cuts, or other serious injury.
Always keep the appliance unplugged during
assembly and disassembly.
When to use the blades:
The cutting blades are used for most chopping,
shredding, and mixing operations.
To install the cutting blades:
1. Fit the attachment into the end of the motor
housing, aligning the three tabs on the blade
assembly with the notches in the motor housing.
2. While holding the motor housing in one hand, turn
the shaft base clockwise until it locks into place.
4
The cutting blades can be removed from the stainless
steel shaft for cleaning or replacement. The cutter
head shaft has left-hand threads to prevent it from
coming loose or slipping during operation.
1. Use a 7/32" wrench
or a pair of needle
nose pliers to hold
the flat portion of the
shaft between the
cutter head and the
guard.
2. While holding the
shaft in place, use a
7/16" wrench to turn
the blades clockwise to loosen the blades.
3. When reinstalling the blades, thread the cutter
head into the shaft counterclockwise, and make
sure it is tightened securely in place.
7/32"
Wrench
7/16"
Wrench