Blaupunkt GT1000 Manual Del Usario página 13

Electrical safety
The device may only be connected to a socket that is correctly installed and grounded.
The fuse must be a residual current circuit-breaker with a measured residual current of no more than 30 mA.
Make sure that the power supply corresponds with the connection specifications of the device before it is connected.
The tool may only be used within the specified limitations for voltage and power (see type plate).
Do not touch the mains plug with wet hands! Always pull out the mains plug at the plug and not by the cable.
Do not bend, crush, pull or drive over the power cable, protect from sharp edges, oil and heat.
Do not lift the device using the cable or use the cable for purposes other than intended.
Check the plug and cable before each use.
If the power cable is damaged immediately disconnect the plug. Never use the device if the power cable is damaged.
If the device is not in use make sure the plug is pulled out.
Make sure that the device is switched o before plugging in the mains cable.
Make sure that the device is switched o before unplugging it.
Disconnect the power supply before transporting the device.