Installation Instructions; Technical Details - Hoover HVG31 Libro De Instrucciones De Uso

INSTALLATION INSTRUCTIONS

TECHNICAL DETAILS

MODELS
Voltage /Frequency
Semi-rapid burner
Rapid burner
Triple crown burner
Automatic ignition
Gas safety device
Product dimension (l x p) mm
Housing dimension (l x p) mm
HVG32
1. Installation
Installation is the buyer's responsibility. The manufacturer accepts no liability for this service. Any action that the manufacturer
has to take due to an erroneous installation will not be covered by the guarantee.
The flush-mounted cook tops are designed for installation in work tops made of all kinds of material, providing they can
withstand a temperature of 100°C, and are between 25 and 40 mm thick. If the cook top is installed in a position so that the side
of a kitchen unit comes up against its left-hand or right-hand side, the distance between the vertical panel and the edge of the
cook top must always be at least 150 mm. The distance between the back wall and the edge of the cook top must be at least 55
mm. A partition made of insulating material (wood or the like) must be inserted between the cook top and the space below. This
partition must be at least 10 mm from the underside of the cook top tray.
X = minimum 150 mm
Z = 10 mm
Y = partition
Fixing the cook top to the unit
The cook top is fixed to the unit by means of the brackets and accessories provided. Holes are provided in the bottom of the tray
where the self-threading plates (A) are inserted so that you can attach the screws (C) that hold the brackets (B) in place.
A = plates for inserting on the bottom
of the cook top
B = fixing bracket
C = screw
Applying the seal
Important - The figure below shows how the seal must be attached all around the perimeter.
This cook top has been designed for non-professional, domestic use.
HVG31
230V/50 Hz
1
Yes
Yes
288x510
275x490
HVG31
15
HVG32
230V/50 Hz
1
1
Yes
Yes
288x510
275x490