Inepro SunTimer 2400 Manual Del Usario página 9

Introduction
®
SunTimer outputs have two neutral relay points to control a connected device over a certain
programmable length of time. This SunTimer
three control keys.
Read this manual carefully to guarantee faultless operation.
Design
* Very resistant plastic housing
* Suitable for internal and external installation
* Three keys: Start/Pause, Timer & Stop (internal and external)
* Bright green 2-digit LED display
* Supply voltage either 24 Volt or 240 Volt
Functioning
®
The SunTimer can be activated with three freely
programmable time-segments. The duration of these
time-segments can be set at 0 to 255 minutes. The
®
SunTimer starts with a prior time. During the prior
time the length of the main time will be shown
intermittently on the display. During the prior time it
is possible to reduce the main time if necessary. The
prior time can also be bypassed so that the main
time will start automatically. During the main time the
remaining time will be shown on the display. The
main time is automatically followed by the post time.
During the post time "Cl" (cool) is displayed.
Registration facilities, as for example start, running
time and service counters can also be used.
Automatic representation of the Running time
counter is affected by pressing the Stop key during 3
seconds. The service counter generates a SR
(service message) on the display.
®
is programmed in a user-optimised way by means of
®
SunTimer 2400 Version 3.0 25-01-2008
- www.inepro.com
Simple reading of the
service counter
Prior time
Quick start function
0-255minutes
Main time reduction
Real time indication
Main time
0-255minutes
Maximum start control
Service counters
Complete registration
facilities
Post time
0-255minutes
Simple reading of the
running time counter
-
9