Procopi Calypso Instrucciones De Instalación página 16

P
OOLS FEATURING STEPS ALONG A LENGTH
IF THE POOL FEATURES STEPS ALONG ONE OF ITS LENGTHS
Inner pool wall
10 cm
Profile
replacing the
coping
Place the separate component above the steps. The axis of the profile replacing the coping should be 10 cm from the inner
pool wall (diagram above). Also ensure that the dimensions "D" are identical to ensure that the profile is correctly
positioned.
Use the profile replacing the coping as a template to drill two holes (Ø10 mm) in the coping at each end. Attach the profile
to the coping by inserting a retaining staple at either end as illustrated.
On the deck, mark the position of the 3 pegs with bushings
that will hold the step tensioning straps according to the
diagram above.
Drill three holes (Ø12 mm, depth 70 mm) and drive a Ø8
mm peg with bushing into each hole. Attach a step tension
strap to each peg. Tighten the straps to tension the step
piece. Slacken the tension on the central strap to avoid
deforming the profile that replaces the coping.
DIRECTLY TO THE INSTRUCTIONS ON THE NEXT PAGE
D D
50 cm
A A A
milieu de l'escalier
Stair midpoint
-
INSTALLATION OF A STEP PIECE
,
INSTALL THE SEPARATE STEP PIECE FIRST
E
Position the Fixkit bungee cords along each edge of the
step piece. The distance between Fixkits (E above) should
be between 50 and 70 cm. Each Fixkit is held in position by
a peg with bushing (Ø 6 mm) driven into a hole (Ø 10 mm,
depth 70 mm) drilled 30 cm from the edge of the steps.
Hook a fixkit around each peg.
16/48
2006/11 - Version: I - Code : 0033860
,
OTHERWISE SKIP
.
E
E