Virax 252938 Manual De Utilización página 4

The mains adaptor is a mains power source that can replace the 14.4 V battery of a 400-450 W / 45 A hand-held
VIRAX power tool under intermittent operating conditions.
General safety instructions
Maintenance and storage
o
Store your tools in a safe place. When not in use, tools should be stored in a dry, closed place, out of reach
of children.
o
Carefully maintain your tools. Keep them clean for better and safer performance.
o
Check the tool for damage. Before using the tool, always carefully check that its various parts are operating
properly. Any guard, switch or other part that is damaged or defective should be properly repaired or
replaced by a qualified technician.
o
Warning! Use the tool and its accessories in accordance with these safety instructions. Also remain within
the limits of the tool, taking into account the working conditions and the task to be performed. Using tools
for other than the intended tasks can be dangerous.
o
This tool is in accordance with all the relevant safety rules. All repairs must be performed by qualified
persons using original manufacturer's spare parts. Failure to do so may be dangerous for the user and
cancel the warranty.
User safety instructions:
o
Keep children away from the tools. Do not allow other people to touch the tool. Keep them away from your
work area.
o
Wear appropriate clothing. Do not wear loose clothing or jewellery, as they can become caught in moving
parts.
o
Rubber gloves and non-slip footwear are recommended when working out of doors. Long hair should be
worn in a hair net.
o
Do not overreach. Avoid adopting a tiring position. Keep proper footing and balance at all times.
o
Be constantly alert. Pay attention to the task, use common sense and do not operate the tool when tired.
Safety instructions regarding the working area
o
Keep the work area tidy. A cluttered work area increases the risk of injury.
o
Consider the work area environment. Do not expose electric tools to the rain. Do not use electric tools in a
damp or wet environment.
o
Keep the work area well lit. Do not use electric tools in the vicinity of flammable liquids or gasses.
Specific safety instructions
o
Read and precisely follow the instructions.
o
Keep the device away from heat and humidity.
o
Do not use a damaged device.
o
Do not unscrew the device.
o
If the LED does not light or flash, this means that the device is faulty. Please unplug it from the mains and
contact the manufacturer.
o
The device must only be repaired by experienced, approved personnel.
o
The device must only be used in compliance with the symbols indicated on the nameplate. Check that the
mains voltage complies with the indicated value.
o
Only use extension leads with a minimum cross-section of 1.5 mm² that have been checked and are in
perfect condition.
o
We recommend that the device is unplugged from the mains when the job is completed or interrupted for a
prolonged period of time.
MAINS ADAPTOR 252938 / 253026