Mitsubishi Electric PAC-SF41SCA Libro De Instrucciones página 17

(2) Unit selection
• Registering a unit in a group
1 The address is incremented each time the TEMP.
time the
three seconds.)
NOTE: The setting ranges for addresses for the various types of registered units are as shown below.
Indoor units and ventilation units : 001 - 050
Local remote controllers
Slave system controllers
* When a unit registered in another group is selected the group select display ( ) for the already
registered group blinks.
2 Press the
• The unit type is displayed when registration is completed normally.
Indoor units
Local remote controller : RC
• [ ] blinks if registration fails.
CENTRALIZED
COLLECTIVE
GROUP ON OFF
Registration complete screen
The indoor unit with address 006 is registered in group 3.
3 Repeat (2) above to register a different unit in the same group. To register in a different group,
select the group and then repeat (1) and (2) above.
NOTE: • Indoor units and ventilation units cannot be registered in the same group. If registration is at-
tempted, [
• When indoor units, ventilation units, and local remote controllers have already been registered in
a different group, they cannot be registered in another group. (Slave system controllers may be
registered in multiple groups.)
switch is pressed. (The skip function operates if the switch is pressed for more than
: 101 - 200
: 000, 201 - 250
switch to register the selected unit in the group.
: IC
ON/OFF
PROHIBIT
CHECK
ON/OFF FILTER
AUTO
MODE TEMP.
BY-PASS
MODE LOCK
HEAT EX.
SKIP
FILTER
˚C
Address to be registered displayed here.
] is displayed and registration does not proceed.
switch is pressed, and decremented each
Ventilation unit : LC
System controller : SC
Type (eg [ ]) displayed if registration is completed normally.
17