Getting Started; Installation Tips; Requirements Cat6 Cable; Installing The Transmitter And Receiver - Marmitek MegaView 241 UHD 2.0 Modo De Empleo

4

Getting started

Installation tips

First switch off all devices (TV and HDMI sources) before connecting them to the

MegaView 241 UHD 2.0™. If a device cannot be turned off, please remove its
plug from the wall socket.
 For the best picture and sound quality, only use High Speed HDMI® certified
cables.
Please be careful when connecting your HDMI cables. These damage easily.


Requirements CAT6 cable

UTP, FTP or STP cable

 24AWG or lower
 Solid twisted pair
 100 ohm at 1MHz
RJ-45 connection according to EIA/TIA T568B standard


Installing the transmitter and receiver

In order to check proper functioning of the system, it is advisable to test the set-up first
using a short CAT6 cable.
1. Switch off all devices prior to installation.
2. Connect the HDMI source (Blu-ray disc player, TV decoder, media center PC,
etc.) to the MegaView 241 UHD 2.0™ transmitter [1] using an HDMI cable (not
included).
3. Connect the MegaView 241 UHD 2.0™ receiver [2] to your TV or projector using
an HDMI cable (not included).
4. Use one CAT6 networking cable to connect the transmitter and receiver of the
MegaView 241 UHD 2.0™ [3].
Please note! The MegaView 241 UHD 2.0™ will only work when using a direct
connection between the transmitter and the receiver and cannot be connected to an
existing home network (LAN), since this may cause damage to the device or your
network router.
5. Connect the power adapter [4] to the "12 VDC" connector of the
MegaView 241 UHD 2.0™ transmitter or receiver and plug the adapter into a wall
socket.
8 © MARMITEK