Correct Operation - Klark Teknik DN200 Manual De Inicio Rápido

16 DN200 Active Stereo DI Box
DN200 controls
Especifi cações
PT
Especifi cações gerais do DN200
Dimensões
Peso líquido
Peso no transporte (bruto)
Requisitos de energia
Consumo de energia
Variação de temperatura em uso
Variação de temperatura em
armazenagem
Comprimento = 142 mm (5,6")
Profundidade = 106 mm (4,2")
Altura = 60 mm (2,4")
0,8 kg
12 unidades = 10,4 kg
Voltagem = +48V
<1W
+5° C a +45° C
-20° C a +60° C
5 Quick Start Guide
Controls
E N
Important: Although the DN200 will
function as a mono device when only
one channel is connected, both channels
must be powered to use stereo, split or
sum modes.

Correct operation

Each input channel is sourced from a balanced
XLR/¼" Jack Neutrik Combo A Series connector
or an unbalanced Phono/RCA connector with
the provision of applying a 20dB pad prior to
the input buff er stage.
As described above, both Left and Right inputs
can be summed to both outputs and the
Left input can be split to both Left and Right
outputs. For full operation, both the Left and
Right outputs should be phantom-powered:
• •
In 'Sum' mode the phantom power
sourced from the left output will also
power the right channel, but with
reduced drive capability. In order for the
DN200 to operate correctly in this mode,
both the left and right outputs should be
connected and phantom-powered.
• • In 'Split' mode, there is no cross-
powering between channels and so
when only one output connection is
made, it should be made to the Left
input. The Right output will only provide
an output signal when the Left output is
also phantom-powered.
Description
1 Unbalanced stereo input phono
connectors with 20kΩ input impedance.
2 Electronically balanced, Neutrik Combo I
Series, stereo input connectors. Connect
either balanced female XLRs (pin 2 hot)
or ¼" Jacks. Input impedances are 20kΩ
and 1MΩ, respectively.
3 20dB pad switch. When on (integral
yellow LED illuminated), 20dB of
attenuation is applied to the signal prior
to the output stage from any stereo
input source.
4 Earth LIFT switch. When on (integral
green LED illuminated), the internal
ground is disconnected from both output
channels. Depending on the grounding
of the connected devices, connecting or
disconnecting the ground will help to
eliminate hum or prevent ground loops.
5 +48V phantom power LED. Illuminates
to indicate that phantom power is on for
its local input.
6 Primary stereo analogue outputs via
transformer balanced XLRs (pin 2 hot).
7 Link stereo outputs via electronically
balanced TRS ¼" Jacks.
8 SPLIT switch. When on (integral blue
LED illuminated), the left input is fed
to the left and right outputs. The right
input is, eff ectively, muted.
9 SUM switch. When on (integral blue LED
illuminated), the left and right inputs
are summed together and fed to the left
output only.
EN EN
ES ES
FR FR
DE DE
PT PT