Step 4 : Alignement - cahors MINISAT Manual Del Usuario

4) Joint Antenna Body with main support and Fix bracket A(B3)
Joint assembled Antenna Body with main support and Fix Bracket A.
In order to support antenna, nut (N1) should be jointed as tightly as it can.
N1
B2
S3

4 - 4 Step 4 : Alignement :

A correct alignment of the antenna requires specialised measurement device owned by your
installer.
- From the Azimuth and Elevation angles taken from the table corresponding to your location,
adjust Azimuth and Elevation settings in order to find the best signal. Proceed in several steps if
required. Your Quality and BER signals must be good.
- after Azimuth and Elevation are correct, adjust slightly the Inclination angle thanks to bolts S1 in
order to minimize the XPOL levels using the spectrum analyser function or the BER indication.
- Secure firmly all the bolts after alignment is achieved.
Antenna alignment menu
Satelite : ASTRA 1
transponder: 23
LNB powe supply : ON
Frequency : 12640
Signal:
B3
N1
B2
S3
Wall
7