Getting Started - Homak HS10036683 Guía De Utilización Y Directivas De Funcionamiento

Inside this manual you will fi nd:
Safety Warnings Before Use

Getting Started

Programming a User Code
Programming a Personal User Code
Programming Steps
LED Light Indications and Troubleshooting
Installing the Unit
Battery Backup
Warranty Information
GETTING STARTED
1. Upon removing your unit from the box, be sure to keep the door from
closing. A plastic stopper is placed on the latch in order to assure it
does not close during shipping.
2. Inside the safe you will fi nd a wire extending from the back of the
keypad and also a battery pack for (4) AA batteries (not included). The
battery pack is attached to the inside of the safe behind the keypad
with velcro. Attach the end of the wire to the battery pack.
*DO NOT CONNECT A 9-VOLT BATTERY TO THE WIRE EXTENDING
FROM THE KEYPAD, DOING SO WILL SHORTEN THE LIFE OF THE
9-VOLT AND THE PISTOL BOX MAY NOT FUNCTION PROPERLY.
3. Insert (4) new alkaline AA batteries into the battery pack. Use new,
name brand batteries. Be sure to check the battery expiration date.
Make sure batteries are placed correctly into battery pack.
4. Make sure your safe operates properly. Before shutting door, enter
your 5-digit manufacturer's code found on the back of this manual.
Latch should activate upon entire code entry and lights should fl ash
green with each entry. If latch/lights do not operate properly, please
call 1-800-874-6625 before going on to Step 5.
5. Remove plastic stopper from door.
6. Shut door.
7. Enter manufacturer's code again. Once entire code is entered, press
on the upper left hand corner of door to open safe.
PROGRAMMING A USER CODE
Your electronic quick access unit is able to be programmed to a personal
user code. If you choose to program your safe to a personal user code,
please be advised that if the user code is lost or forgotten, your unit will
not longer be covered under warranty if you are unable to gain entry.
When programming a user code, we recommend using a series of 4-5
letters, and/or digits. The default factory code will always remain active
even when a personal user code is programmed.
- 2 -