Troubleshooting - Ryobi RLM46175SL Traducción De Las Instrucciones Originales

TROUBLESHOOTING

Problem
The handle is not in The handle is positioned incorrectly.
the correct position.
The handle knobs are not tightened.
The mower does There is no petrol.
not start.
The engine is flooded.
The starter rope is harder to pull now
than when it was new.
The mower is hard The grass to be mowed is too tall.
to push.
The mower housing and blade is being
dragged through heavy grass.
The cutting height is too low.
The wheel assembly needs
T h e m o w e r i s The blade is unbalanced.
vibrating at a higher
speed.
The motor shaft is bent.
The grass catcher The discharge chute is blocked.
is not being filled
up with grass even
t h o u g h g r a s s i s
being cut from the
lawn.
12
Possible cause
cleaning.
Solution
Check and ensure that the lower part of handle is pushed
fully back and snapped into proper position.
Tighten the handle knobs..
Fill the mower with petrol. If the mower still does not start,
contact an authorised service
Wait for 15 minutes, then try starting the mower again. Do
not prime before attempting to start.
Contact an authorised service centre.
Raise the cutting height.
Clean the wheel assembly. See the Drive Gear
Maintenance section.
Replace the blade.
Stop the product. Make sure that all moving parts have
come to a complete stop. Allow the product to cool down.
Disconnect the spark plug wire. Inspect for damage. Have
the damage repaired by an authorised service centre
before restarting the product.
Stop the product. Make sure that all moving parts have
come to a complete stop. Allow the product to cool down.
Disconnect the spark plug wire. Remove grass catcher
and lift discharge chute cover. Beware of the sharp blade
and avoid contact. Remove the debris from the discharge
chute.
English
centre..