Making And Answering Vco Calls - Ameriphone VCO Manual Del Instrucciones

Sp­ec­ial Feat­ur­es
To St­or­e t­he Sec­ond 5 Number­s
Int­o t­he Same memor­y Loc­at­ions:
1. Lift the handset and press
PROG as shown in Figure 25.
2. Enter the phone number on the
keypad just as you would dial it
normally, as shown in Figure 26.
3. Press the mEmORY b button
and then the desired MEMORY
(M1-M5) button (Figure 24) to
store this number as the
second phone number in the
same memory location.
making St­andar­d Phone Calls
1. Make or answer voice
calls as usual.
2. Press the AMPLIFY button
(FIGURE 27) to turn amplifier
ON/OFF.
3. Adjust VOLUME and TONE
slide controls to suit your hearing
4. Hang up to reset.
*
HOLD PROG
TONE
LO
Figure 27 - AmPLIFY Button
Using Relay wit­h VCO
A person with hearing loss who
uses their voice can use voice
carry over (VCO) through the
toll-free local relay service to
communicate with a hearing
person.
In a VCO (voice carry over) call,
the hard of hearing person speaks
directly to the other party. The
Communications Assistant (CA)
relays the response from the other
person, which shows up as text on
your VCO phone screen. You just
read and talk.
It is not possible to speak to
the other person or to the CA
while the VCO is receiving text
messages. You must wait for the
completed message as
0 #
O
P
E
FLASH REDIAL
AMPLIFY
VOL
HI
E
N
G
L
I
S
H
17