Hilti SF 2H-A Manual De Instrucciones Original página 19

▶ Check the tool and batteries for damage before use after long periods of
transport.
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a
window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by
children or unauthorized persons.
▶ Check the tool and batteries for damage before use after long periods of
storage.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, please contact Hilti Service.
8.1 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, contact
Trouble or fault
The power tool
doesn't run.
The control switch
can't be pressed, i.e.
the switch is locked.
The battery runs
down more quickly
than usual.
The battery doesn't
engage with an audi-
ble click.
*2125997*
Printed: 19.06.2019 | Doc-Nr: PUB / 5245424 / 000 / 04
Possible cause
The battery is not fully
inserted.
Low battery.
The forward/reverse
selector switch is in the
middle position.
Very low ambient tem-
perature.
The retaining lugs on the
battery are dirty.
2125997
Service.
Action to be taken
▶ Push the battery in
until it engages with
an audible click.
▶ Charge the battery.
▶ Push the
forward/reverse
switch to the left or
right.
▶ Allow the battery to
warm up slowly to
room temperature.
▶ Clean the retaining lug
and push the battery
in until it engages.
Contact Hilti Service if
the problem persists.
English 13