Product-Dependent Symbols; Symbols On The Product; Product Information; Declaration Of Conformity - Hilti SF 2H-A Manual De Instrucciones Original

These numbers refer to the corresponding illustrations found at the
beginning of these operating instructions
The numbering reflects the sequence of operations shown in the
illustrations and may deviate from the steps described in the text
Item reference numbers are used in the overview illustrations and
refer to the numbers used in the product overview section
This symbol is intended to draw special attention to certain points
when handling the product.
Wireless data transfer

1.3 Product-dependent symbols

1.3.1 Symbols on the product

The following symbols are used on the product:
Rated speed under no load
Revolutions per minute
Direct current (DC)
Screwdriving
Drilling without hammer action
Drilling with hammering action (hammer drilling)

1.4 Product information

products are designed for professional users and only trained,
authorized personnel are permitted to operate, service and maintain the
products. This personnel must be specifically informed about the possible
hazards. The product and its ancillary equipment can present hazards if
used incorrectly by untrained personnel or if used not in accordance with
the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to
state the product details when contacting Hilti Service or your local Hilti
organization to inquire about the product.
Product information
Type:
Generation:
Serial no.:

1.5 Declaration of conformity

We declare, on our sole responsibility, that the product described here
complies with the applicable directives and standards.
2 English
Printed: 19.06.2019 | Doc-Nr: PUB / 5245424 / 000 / 04
SF 2H-A
01
2125997
*2125997*
A copy of the