Placing Tool In Service - Ingersoll Rand 344 Instrucciones

WARNING
Always wear eye protection
when operating or
performing maintenance
on this tool.
LUBRICATION
Ingersoll- - Rand No. 50
Always use an air line lubricator with these tools.
We recommend the following Filter- - Lubricator- - Regulator
Unit:
For International - - No. C16- - C3- - A29
For USA - - No. C11- - 03- - G00
Use a 3/8" inner diameter hose with a 1/4" connection.
Before starting the tool and after each two hours of
operation, unless the air line lubricator is used, detach the
air hose and inject about 1 cc of oil into the air inlet.
After each eight hours of operation, or as experience
indicates, inject about 1 cc of the recommended grease
into the Grease Fitting.
Model Free Speed
rpm
344 13500
3445 12000
H
Tested in accordance with PNEUROP PN8NTC1.2
Tested in accordance with ISO8662
WARNING SYMBOL IDENTIFICATION
Read this manual before
operating tool.

PLACING TOOL IN SERVICE

Ingersoll- - Rand No. 67
SPECIFICATIONS
Wheel Wheel Type
Capacity
in (mm)
4 (102) 27
4-1/2 (114) 27
3
WARNING
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
FILTER
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
HSound Level
Maximum
Wheel dB (A)
Thickness
in. (mm) Pressure
1/4 (6.4) 83.9
1/4 (6.4) 85.7
WARNING
Always wear hearing
protection when operating
this tool.
COMPRESSOR
(Dwg. TPD905- -1)
Vibrations
Level
2
Power m/s
- - - - - - 5.9
- - - - - - 5.2