Advice Regarding The First Wash Cycle; Technical Data; Transportation - Hotpoint Ariston LFF 8M113 7 Manual De Instrucciones

Anti-condensation strip
EN
After installing the dishwasher, open the door and stick the
adhesive transparent strip under the wooden shelf in order
to protect it from any condensation which may form.

Advice regarding the first wash cycle

After the installation, remove the stoppers from the racks and the
retaining elastic elements from the upper rack, if any.
Immediately before the fist washing,
dispenser with water and add only then approximately 1
(see chapter entitled Rinse aid and refined salt)
kg of salt
The water may overflow: this is normal and is not a cause
for concern. Select the water hardness value
entitled Rinse aid and refined salt).
poured into the machine, the LOW SALT indicator light
switches off.
If the salt container is not filled, the water softener and
the heating element may be damaged as a result.

Technical data

Dimensions
Capacity
Water supply
pressure
Power supply voltage
Total absorbed power
Fuse
6
*
completely fill the salt
(see chapter
- After the salt has been
width 60 cm
height 85 cm
depth 60 cm
14 standard place-settings
0,05 ÷ 1MPa (0.5 ÷ 10 bar)
7,25 – 145 psi
See appliance data plate
See appliance data plate
See appliance data plate
This dishwasher conforms to the
following European Community
Directives:
-2006/95/EC (Low Voltage)
-2004/108/EC (Electromagnetic
Compatibility)
-2009/125/EC (Comm. Reg.
1016/2010) (Ecodesign)
-97/17/EC (Labelling)
-2012/19/EU Waste Electrical
and Electronic Equipment
(WEEE)
The machine has a buzzer/set of tones
dishwasher model
) to inform the user that a command has
been implemented: power on, cycle end etc.
The symbols/indicator lights/LEDs on the control panel/
display may vary in colour and may have a flashing or fixed
(depending on the dishwasher model)
light
The display provides useful information concerning the type
of wash cycle, drying/wash-cycle phase, remaining time,
temperature etc etc.
.

Transportation

*
Unload all crockery from the dishwasher and secure moving
parts.
All water remaining inside the appliance should be drained
as follows:
make sure that the water tap is open and select the ECO cycle.
The cycle will begin. After 5 minutes, end the cycle by pressing
the ON/OFF button until you hear a beep and the indicator lights
switch off. Wait for approximately 5 minutes before uninstalling
the appliance. Shut off the tap and disconnect the inlet and
drain hose.
The appliance should only be moved in an upright position, in
order to prevent any water remaining inside the appliance from
damaging dishwasher components.
Leaving the machine unused for extended periods/
Freezing protection
If the appliance is situated in a location which is at risk of freezing,
or if you intend to be away for extended periods of time (e.g.
holiday home) , empty the appliance completely.
- Carry out the process used to drain all water remaining inside
the appliance (see Transportation).
- Disconnect the appliance from the electricity supply and shut
off the water tap.
- Leave the appliance door ajar.
- When you return, run a cycle while the dishwasher is empty.
*
Only available in selected models.
(depending on the
.