Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
F R O N T P A N E L
1
POWER SWITCH (1)
This 2-position rocker switch applies mains power to the unit
when in the ON position.The red LED located to the right of
the Power switch indicates that Power is ON.
MODE SWITCH (2)
This switch selects between stereo 2-way operation and mono 3-way operation.The red LED above the Mode
switch indicates mono mode.
INPUT GAIN CONTROL (3)
This control is used to optimize the gain between the mixer and the power amps.The control range is
between 0 dB and +12 dB.
LOW GAIN CONTROL (4)
This controls the output level of low frequency signals (those below the selected crossover point) present at
the low output XLR.
HIGH GAIN CONTROL (Channel 1) (5)
This function is non-operational in MONO Mode.
CROSSOVER SELECTOR CONTROL (lows/mids) (6)
This allows the user to choose their desired crossover point for lows and mids. Control range is between 100
Hz and 1 kHz or 1 kHz and 10 kHz depending on the position of the Range Switch.
RANGE (x10) SWITCH (lows/mids) (7)
This switch multiplies the value indicated on the Crossover Selector Control times 10.When engaged, the
range will change from 100 Hz to 1 kHz through 1 kHz to 10 kHz. Range x10 is indicated by the illumination
of the red LED above the switch.
INPUT GAIN CONTROL (Channel 2) (8)
This function is non operational in MONO Mode.
MID GAIN CONTROL (9)
This controls the output level of mid signals (those below the selected crossover point) present at mid output
XLR.
HIGH GAIN CONTROL (10)
This controls the output level of the highs (signals above the selected crossover point) present at high output
XLR.
M O N O M O D E O P E R A T I O N
2
3
4
5
6
7
THE ON/OFF SWITCH IN THIS APPARATUS
DOES NOT BREAK BOTH SIDES OF THE MAINS.
HAZARDOUS ENERGY MAY BE PRESENT INSIDE
THE ENCLOSURE WHEN THE POWER SWITCH IS
IN THE OFF POSITION.
11
8
9
10
11
WARNING
12
Publicidad
Tabla de contenido
