ENGLISH
WARNING
!
To reduce the risk of electric shock, turn Power
Switch off and disconnect plug from electrical
outlet before performing maintenance or
troubleshooting checks.
MAINTENANCE & CARE
Check Rotating Floor Brush & Drive Belt
You should check your vacuum cleaner's rotating floor
brush and drive belt regularly for wear or damage. You
should also clean the brush and brush ends of string, hair,
and carpet fibers. These can wrap around the brush and
hamper its ability to effectively clean your carpet. Also
remove any debris that has accumulated under the brush
cover.
• Unplug cleaner from electrical outlet.
• Place handle in low position and turn vacuum cleaner
over so bottom side is up.
Fig. 1 Remove the four screws as shown with a Phillips-
head screwdriver. Lift the brush cover off.
Fig. 2 Grasp rotating floor brush at both ends and lift.
Clean strings, hair and other debris from rotating
floor brush, paying particular attention to brush
ends.
Fig. 3 Clean strings, hair and other debris from motor
pulley and drive belt areas.
Check drive belt carefully for wear, cuts or
stressed areas. Replace if worn.
Fig. 4 Check air passageway for obstructions. Remove
debris from this area.
Replace Drive Belt
Use only SANITAIRE
®
Belt (model number: 2923) in your vacuum.
• Unplug cleaner from electrical outlet.
• With rotating floor brush removed from vacuum cleaner
(Steps 1-4 of Check rotating floor brush and drive belt),
grasp old drive belt and remove from motor pulley.
Discard old drive belt.
• Place new drive belt over motor pulley and stretch other
end over rotating floor brush in the space between the
bristles.
• Place ends of rotating floor brush down into slots on
sides as shown.
• Turn rotating floor brush by hand several times in
direction of motor pulley. If properly installed, drive belt
will center itself.
• Reposition brush cover and four screws. Tighten
screws securely. Make sure end of brush cover is
snapped into place.
16 www.sanitairecommercial.com
(Fig. 5)
Professional Style B Replacement
Fig. 1
Fig. 2
Motor Pulley
Fig. 3
Polea del motor
Poulie du moteur
Press here
Presione aquí
Appuyez ici
Fig. 5
Brush Cover
Cubierta del cepillo
Couvercle de la brosse
Fig. 4
Air Passageway
Conducto de aire
Entrée d'air
Brush Cover
Cubierta del cepillo
Couvercle de la brosse