Montarbo W440A Manual De Instrucciones página 12

Example 4 :
This setting attenuates the
middle frequencies in the central
voice range.
• When driving the system directly
from the input set to 'microphone'
this will result in a grater 'presence'
or 'loudness' of the voice, but will reduce the intelligibility.
Note: this setting is not suggested when driving the system from
the line input, using the mixer's output, because the W440A'
settings will add to the adjustment made with the mixer's tone
controls and graphic equalizer (if present).
The desired tonal balance should be obtained with the mixer's
controls.
Example 5 :
Further rotation of MID control will
result in a grater voice range
attenuation. The 'voice loudness'
effect is increased, at the expense
of a reduced dynamic range.
This setting should be used at very
low levels.
Important !
Product care and maintenance
• Do not expose the enclosure to heat sources (lamps, lights,
high power light sources, radiators or other products that
produce heat).
• Never place burning candles or other sources of open flame on
top of the device.
• Never expose the enclosure to direct sunlight, excessive
vibrations or mechanical shocks.
• Avoid operating and storing the enclosure in damp or dusty
places: this may lead to malfunctions and premature degrading
of specifications.
• Avoid using the system close to strong sources of electromagnetic
interferences (e.g. video monitors, high power electrical cabling).
This may lead to degradation of audio quality.
• When setting up the system up outdoors, be sure to protect it
against rain.
active, processor controlled, bi-amped speaker system
• Care should be taken so that objects do not fall and liquid is not
spilled onto the enclosure. In public event don't let people,
musicians, technicians or anyone put glasses, cups, ashtrays or
cigarettes on the enclosure.
• Always leave the protective grid mounted on the enclosures.
• Use a soft brush or a jet of air to clean the enclosure.
Do not use alcohol, solvents or detergents.
• Take care of your connector cables. Make sure that they are not
damaged, knotted or twisted.
• Do not force connectors and controls.
• Make sure the mains power switch is off ('0') before starting any
connection.
• As long as it is plugged in there can be dangerous electrical
potentials inside the device, so, before undertaking any sort of
maintenance work etc., always make sure it has been unplugged
from the mains socket.
W440A
➝
13
ENGLISH