Porter Cable 7812 Manual De Instrucciones página 8

FIG. 5
3. Disconnect appliance from power circuit
4. Pull upward on the filter cover lock, located on rear of the motor unit (see
Fig. 6) to expose the filter.
5. Remove the filter (see Fig. 7) and tap it to remove any loose dirt.
6. If the filter is still dirty, clean it under running water (see Fig. 8). If this does not
adequately clean the filter, replace it.
NOTE: Allow wet filter to dry before re-installing it in the appliance.
NOTE: A small sponge filter is located next to the top filter. This filter helps
to cool the motor. Check the filter on a regular basis. If it is dirty, clean it by
blowing dry compressed air through it.
FIG. 7
DRY PICK-UP
Do not pick up anything that is burning, smoldering or smoking
such as matches, cigarettes or hot ashes. Do not use to vacuum combustible
explosive materials, such as coal, grain or other finely divided combustible
material. Do not use to vacuum hazardous, toxic or carcinogenic materials, such
as asbestos, pesticide or lead-based paint debris.
The vacuum cleaner may be used to pick up dry material with or without a dust bag
installed. The dust bag provides a convenient method for disposing of the material
that is collected.
Always use a dust bag when collecting fine dust. The bag will reduce clogging of
the flat filter, and increase dust holding capacity.
WET PICK-UP
Never pick-up explosive liquids (e.g. gasoline, diesel fuel, heating
oil, paint thinner, etc.), acids or solvents.
C
8- ENG 8- ENG
FIG. 6
FIG. 8