Garmin MONTANA 600 Serie Instrucciones página 2

See the Important Safety and Product Information in the Montana product box
before installing the marine mount.
Always wear safety goggles, ear protection, and a dust mask when drilling,
cutting, or sanding.
Incorrectly wiring the power or audio cable with bare wire leads can result
in damage to the boat or the battery. Garmin strongly recommends having an
experienced installer with the proper knowledge of electrical systems install the
mount.
The metal contacts on the Montana and the mount should be kept dry to avoid
equipment damage. Use the weather cap on the mount at all times when the unit is
not mounted to keep the metal contacts dry and protected.
Tools and Fasteners needed
• Drill
• Hardware for the swivel mount: 3 bolts or 3 screws (not included)
◦ #8 (4 mm) pan-head machine bolts with matching nuts and washers and
a 5/32 in. (5 mm) drill bit
◦ #8 (4 mm) pan-head self-tapping screws and a 1/16 in. (1.5 mm) drill bit
for drilling starter holes
2
Warning

CaUTiOn

notice
Montana 600 Series Marine Mount Instructions