Installing The Side Brush; Batteries / Chargers - Kärcher KM 85/50 R Bp Manual Del Usuario

4 Unscrew 4 marked flooring boards fastened with screws to the
pallet.
5 Position these 4 boards on the edge of the pallet; align the
boards such that they are beneath the wheels when driving the
device off the pallet.
6 Place wooden blocks and a board and secure them using
screws beneath the flooring boards to support them (see illus-
tration).
7 Drive or push the device off the pallet using the ramp created
(see chapter "Precommissioning | Pushing / driving the de-
vice").

Installing the side brush

Note
The side brush is already installed when the device is delivered
but it is fastened inwards with a cable tie.
1. Cut the cable tie before commissioning the device.
Pushing / driving the device
DANGER
Risk of accidents due to absence of braking power
Secure the device to prevent it from rolling away before you ac-
tuate the neutral lever.
Neutral lever
1
A position: device can be driven with its own drive
B position: device can be pushed
1. To push the device, push the neutral lever down (OFF).
2. After pushing, pull the neutral lever up (ON).

Batteries / chargers

ATTENTION
Only use the batteries and chargers recommended by the manu-
facturer.
Only use rechargeable batteries.
Only replace batteries with batteries of the same type.
Before disposing of the vehicle, remove the battery and dispose
of it in accordance with national or local regulations.
Warnings symbols
Please observe the following warnings when handling batteries:
Observe information in the user manual of the battery
and on the battery as well as in these operating in-
structions.
Wear eye protection.
Keep children away from acid and batteries.
Risk of explosion.
Fire, sparks, naked flames and smoking must be
strictly avoided.
Risk of chemical burns.
18
First aid.
Warning note.
Disposal
Do not throw the battery into the bin.
DANGER
Risk of fire and explosion
Do not place tools or other objects on the battery.
Naked flames and smoking must be strictly avoided.
Ensure the room is well ventilated when charging batteries.
Only use batteries and chargers approved by Kärcher (original
spare parts).
WARNING
Environmental risk due to improper disposal of batteries
Ensure that defect or used batteries are disposed of safely (con-
tact a waste management company or Kärcher Service).
Procedures in the event of unintentional release of battery
When used normally, and when observing the instructions, lead-
acid batteries do not pose any risk.
However, keep in mind that lead-acid batteries contain sulphuric
acid, which can cause serious chemical burns.
1. If there is spillage or if the battery is leaking and acid is escap-
ing, lay down a binding agent such as sand. Do not let it reach
the sewer system, soil or any body of water.
2. Neutralise the acid with lime/baking soda and dispose of it ac-
cording to local regulations.
3. Contact a waste management company to dispose of faulty
batteries.
4. Rinse thoroughly with lots of clear water if acid gets into eyes
or comes in contact with the skin.
5. Thereafter consult a doctor immediately.
6. Wash out the acid with water if it comes in contact with clothes.
7. Change clothing.
Order numbers and dimensions of batteries and
Note
The 85/50 R Bp Pack sweeper variant is supplied with batteries
and charger.
 Kärcher order numbers for recommended batteries and charg-
ers
Battery Order no. *
Maintenance-
free
12 V / 105 Ah 6.654-141.0 2.64
* Device requires 2 batteries
** Minimum volume of battery charging room
*** Minimum airflow between battery charging room and environ-
ment
Maximum dimensions when using other
batteries
L x W x H
Charger
24 V / 12 A
English
Safety instructions
acid
chargers
Volume
3
m **
408x348x284 mm
Order no. Required quantity
6.654-367.0 1
Airflow
3
m /h ***
1.06