Grundig TA 4620 Manual De Usuario página 21

OPERATION ______________________________
Preparation
1
Remove all packaging and sticker materials
and dispose of them according to the appli-
cable local regulations.
2 Before using the appliance for the first time,
clean the appliance (see the "Cleaning and
care" section).
3 Make sure that the appliance is in an upright
position and on a stable, flat, clean, dry and
nonslip surface.
Note
When using the appliance for the first time,
7
smoke can develop due to production resi-
dues. However, this does not mean the appli-
ance is defective. The first time you switch it on
use the appliance as you normally would but
without bread. It is recommended to use the
medium setting of the browning control
first usage. Ensure for proper room ventilation.
Toasting
1
Connect the power plug into the wall socket.
2 Insert only one slice of bread in each of the
two bread slots .
A
3 Using the browning control
sired degree of browning between 1 and 7.
Notes
Turning the browning control
7
the lightest degree of browning and turning
it to 7 the darkest. The browning degree can
vary depending on the type of bread.
The lowest degree of browning is the white
7
color, and the highest is puce. The bread slice
can be toasted to golden color at the position
of "4".
When toasting several slices of bread consecu-
7
tively, the toaster will become hotter and there-
fore the bread will gradually become darker.
Therefore select an appropriate browning
degree. Let the toaster cool down after each
toasting process for minimum 30 seconds.
for
D
select the de-
D
to 1 will give
D
The degree of browning of one slice is darker
7
than two slices, although the browning
control is set to the same level.
D
4
Press the start lever
cally snaps into place.
– The toasting process begins. The indicator
light of the stop button
the toasting process.
Notes
If the power plug is not connected into the wall
7
socket, the start lever
place.
The degree of browning can also be adjusted
7
during the toasting process with the browning
control .
D
5
The appliance automatically switches off as
soon as the set degree of browning has been
reached.
– The start lever
B
stop button light goes off. The toast slices
E
are pushed upwards and can be taken out
of the toaster.
Notes
To cancel the toasting process before it has fin-
7
ished, press the stop button
springs back up and the toast slices can be
B
taken out of the toaster.
Caution
Be very careful when taking the toast slices out
7
of the toaster as the metal parts of the toaster
and also the bread can become very hot.
6
Disconnect the appliance from the wall socket.
If toast slices get stuck in the toaster, switch the
7
toaster off immediately by pressing the stop
button . Pull the power plug out of the wall
E
socket. Let the toaster cool down completely.
Carefully try to take the bread out of the toaster
without damaging the sensitive heating ele-
ments and other parts. Do not use any electro-
conductive objects to remove the bread from
the toaster.
down until it automati-
B
illuminates during
E
does not snap into
B
springs back up and the
. The start lever
E
ENGLISH 21