König Electronic CMP-NWIPCAM11 Manual De Uso página 9

[Area set]: Click the left mouse button and drag the mouse to delimit the masking
area.
[Clr]: Used to clear the set masking area.
[All]: Indicates the entire video area is the masking area. After the parameters are set,
click <Save>, and the settings will take effect.
Motion Detection Settings of IP Camera
The interface for setting the Motion parameters of the IP Camera is as follows:
The motion detection area is divided in to 22x18 blocks. When you double click one of
the blocks you can set or cancel the motion detection for that area. Furthermore you
can set the alarm detection time, alarm detection switch, and motion alarm detection
settings. After the parameters are set, click <save> and the settings will take effect.
[Area set]: Click and drag the mouse to delimit the detection area. To select multiple
areas, press the <Ctrl> key while selecting an area. Selected areas will be
highlighted in red.
[Clr]: Used to clear the set motion detection area.
[All]: Sets the entire video area as the motion detection area.
[Time]: Set different time periods for motion detection, for example, from 00:00 to
23:59 each day.
[Enable Detect]: If the check box is selected, dynamic detection and alarm is allowed
in the range of the set detection sensitivity. The value range of
sensitivity is 1 ~ 100. The greater the value, the higher the sensitivity
will be. The default value is 80.
[Alarm record in PC]: If the check box is selected, the video of the camera will be
recorded after it detects motion. The recording time for each
alarm is 30 seconds. When the system detects a dynamic
alarm, the alarm on the interface will blink, and the left column
will give a prompt of alarm time.
9