SodaStream PLAY Guía Rápida De Inicio página 7

INSTALL THE CO CARBONATOR
Adaptor
Collar
2
1. Place the PLAY™Soda Maker on
a flat, sturdy surface, then gently
lay it down on its back with the
c a r b o n a t i n g b l o c k f a c i n g
upwards.
2. Remove seal and cap from the
SodaStream CO carbonator.
Remove the carbonating bottle
stored inside the PLAY™ and
then insert the CO carbonator
i n t o t h e o p e n i n g o f t h e
carbonator hollow at the base of
TM
the PLAY Soda Maker and turn
the CO carbonator clockwise
2
while applying gentle pressure
until it is firmly held in place.
Hand-tighten only; do not use
tools.
TM
If the PLAY Soda Maker is not
laying on its back with the
c a r b o n a t i n g b l o c k f a c i n g
upwards, a safety gate will block
the carbonator hollow and you
will not be able to fully insert the
carbonator.
If using a 130L carbonator,
remove the carbonator adaptor
collar by pulling it out from the
base of the unit.
3. Place your PLAY™Soda Maker
back in the upright position.
You are ready to create the
bubbles.
2
2
7