Schlage FE595 Instrucciones De Instalación página 5

7
Connect wire and battery.
9
Install cover.
10
If needed, switch levers.
Correct
Incorrect
Lock will beep when
battery is connected.
Actual Size
If your lever looks like this,
then no change is necessary.
If your lever does not look
like this, switch the levers by
following the steps below.
a b
Insert the pin wrench Pull the lever off.
into the hole in the
lever. Push in and
hold.
8
Place battery in holder and tuck wires.
OR
c
Repeat steps a and b to remove the
lever from the other side of the door.
Switch the levers.
Route wires behind curved
piece and tuck, using tabs, so
they will not be pinched by the
cover.
Tabs
Curved Piece
d
Push each lever back
into place.