Publicidad
Idiomas disponibles
Idiomas disponibles
It is important to follow all instructions shipped with this product. This device is to be
installed by a trained electrician who is thoroughly familiar with the National Electrical Code
and will follow the NEC Guidelines as well as local codes.
This device should be considered a part of the signaling system and not the entire
signaling system.
The selection of the mounting location for the device, its controls and the routing of
the wiring are to be accomplished under the direction of the facilities engineer and the
safety engineer. In addition, listed below are some other important safety instructions and
precautions you should follow:
•
Read and understand all instructions before installing or operating this equipment.
•
Do not connect this sync module to the system when power is on.
•
After installation, test the system to ensure that it is operating properly.
•
After testing is complete, provide a copy of this instruction sheet to all operating
personnel.
•
Establish a procedure to routinely check the installation for integrity and proper operation.
Failure to follow all safety precautions and instructions may result in property damage,
serious injury, or death to you or others.
A.
UNPACKING.
After unpacking the unit, examine it for damage that may have occurred in transit. If the
equipment has been damaged, do not attempt to install or operate it, file a claim immediately
with the carrier stating the extent of the damage. Carefully check all envelopes, shipping labels
and tags before removing or destroying them.
B.
GENERAL.
The Federal Signal's strobe synchronization module SSM is designed to sync low
inrush current 24VDC models 3 Fireball, or 3 Electra ray, 2 27XST or 2 FSEX strobes. The
SSM accepts strobe input from control panel or a power supply and provides sync output
to the strobes. The SSM is UL Listed under Standard 1971(Emergency Appliances for the
Hearing Impaired) for indoor use. The 24VDC input to the sync module SSM is polarized for
compatibility with standard reverse polarity supervision of signaling circuit of control panel.
Following strobe models are available for use with SSM.
INSTALLATION INSTRUCTIONS
FOR STROBE SYNCHRONIZATION MODULE
MODEL SSM
SAFETY MESSAGE TO INSTALLERS
-1-
Publicidad
