Toro 20601 Manual Del Operador página 2

Installation
1
Installing the Clamps
Parts needed for this procedure:
4 Phillips screw
2 Pan head screw
2 Inner clamp
2 Outer clamp
2 Vertical tube
2 Angle adjuster
Procedure
1. Within the lower third of the handlebar, place the
inner clamp on the inside of handlebar (Figure 1).
3
2
1
G015775
Right-hand handlebar shown
1. Phillips screw
2. Inner clamp
3. Outer clamp
4. Mower handlebar
2. Place outer clamp on the outside of handlebar, with
the word Up facing upward (Figure 2), and connect
the two clamps to the handlebar using 2 phillips
screws (Figure 1).
Important: Do not fully tighten phillips screws
as height adjustments will be made later.
6
5
4
Figure 1
5. Vertical tube
6. Angle adjuster
7. Pan head screw
G015781
1. Lower third of mower handlebar
3. Set the vertical tube into the angle adjuster. Make
sure that the top portion of the vertical tube rests flat
7
on the inner portion of the angle adjuster (Figure 1).
4. Use the pan head screw to attach the vertical tube
and angle adjuster to the clamp assembly as shown
in Figure 1.
Important: Do not fully tighten pan head screw,
as angle adjustments will be made later.
5. Repeat this process for the opposite handlebar.
2
1
Figure 2