Using Ac Power; Power Supply - Philips AZ1560/17 Manual Del Usuario

Whenever convenient, use the AC power supply if you want to
conserve battery life. Make sure you remove the plug from the
set and wall outlet before inserting batteries.
BATTERIES (OPTIONAL)
1. Open the battery compartment and insert six batteries, type
R-20, UM-4 or D-cells, (preferably alkaline) with the correct
polarity as indicated by the "+" and "-" symbols inside the
compartment.
2. Replace the compartment door, making sure the batteries are
firmly and correctly in place. The set is now ready to operate.
– If BATT LOW lights up, battery power is running low.
– The BATT LOW indicator eventually goes out if the
batteries are too weak.
– Incorrect use of batteries can cause electrolyte leakage and
will corrode the compartment or cause the batteries to burst.
Therefore:
– Do not mix battery types, e.g. alkaline with carbon zinc.
Only use batteries of the same type for the set.
– When inserting new batteries, do not try to mix old
batteries with the new ones.
– Remove the batteries if the set is not to be used for a long
time.
– Batteries contain chemical substances, so they
should be disposed of properly.

USING AC POWER

1. Check if the mains voltage as shown on the type plate
located on the bottom of the set, corresponds to your local
AC power supply. If it does not, consult your dealer or service
center.
2. If your set is equipped with a voltage selector, adjust the
selector so that it matches with the local power.
3. Connect the power cord to the wall outlet and the set is now
ready for use.
4. To disconnect the set from the power completely, remove the
plug from the wall outlet.

POWER SUPPLY

6 x D-cells - R20 - UM4
MAINS
9