Power Supply - Philips AZ 3010 Guia De Inicio Rapido

English CONTROLS
Top and front panels (See
1VOLUME
– adjusts volume level
2DBB (Dynamic Bass Boost)
– enhances bass response
3Source selector
– selects source of sound CD or TUNER. Also the
power off switch
4Display
– shows the CD and tuner functions
5FM•MW (AM)
– selects FM/ MW (AM) waveband
6LIFT TO OPEN
– opens/ closes the CD door
7PRESS TO PLAY 2;
– starts or pauses CD play
8STOP 9
– stops CD playback; erases a CD programme
9SEARCH ∞ , §
CD: skips or searches a passage/track
backwards or forward
Tuner: tunes to a station (up, down)
0PRESET +, –
– selects a preset station (up, down)
!PROG MODE
CD: – programmes and reviews programmed
track numbers;
– plays tracks CD/ programme in random
order;
– repeats a track/CD/ programme
Tuner: – programmes preset stations
1
Back Panel (See )
@Telescopic aerial
– to improve FM reception
#Battery door
– to open battery compartment
$AC MAINS
– inlet for mains lead
All manuals and user guides at all-guides.com
1
)

POWER SUPPLY

Power Supply
Whenever convenient, use the power supply if you
want to conserve battery life. Make sure you remove
the plug from the set and wall socket before inserting
batteries.
For users in the U.K.: please follow the instructions in
the box, Important notes for users in the U.K.
Batteries (not included)
Open the battery compartment and insert six
batteries, type R-14, UM-2 or C-cells, (preferably
alkaline) with the correct polarity as indicated by the
"+" and "–" symbols inside the compartment.
Batteries contain chemical substances, so they
should be disposed of properly.
Incorrect use of batteries can cause electrolyte
leakage and will corrode the compartment or cause
the batteries to burst. Therefore:
• Do not mix battery types: e.g. alkaline with carbon
zinc. Only use batteries of the same type for the
set.
• When inserting new batteries, do not try to mix old
batteries with the new ones.
• Remove the batteries if the set is not to be used
for a long time.
Using AC Power
1 Check if the mains voltage, as shown on the type
plate located on the bottom of the set, corresponds
to your local mains supply. If it does not, consult
your dealer or service centre.
2 Connect the mains lead to the AC MAINS inlet and
the wall socket. The power supply is now
connected and ready for use.
3 To switch off completely, unplug the mains lead
from the wall socket.
• Unplug the mains lead from the wall socket to
protect your set during heavy thunderstorms.
The typeplate is located on the bottom of the set