Rowenta INTENSE PURE AIR PU4020 Serie Manual De Instrucciones página 10

3D PURE AIR FUNCTION (adjustable grid)
You can adjust the position of the air outlet grid manually, as desired. For an optimum, even flow
of purified air in the room, set the angle to 45°; for optimized well-being, set the angle to 90°.
MAINTENANCE
Always switch the appliance off with the button (8) and unplug it before conducting any
maintenance operation.
You can clean the outer of the appliance with a slightly damp cloth.
IMPORTANT: Never use abrasive products which could damage your appliance's appearance.
FILTERS
Filter
Pre-filter
Active carbon filter
True HEPA Allergy+ filter
NanoCaptur filter
This data is based on an average use of 8 hours per day at speed 2.
The recommended frequency for cleaning and replacing the filters may vary depending on the
duration of use and the operating environment.
• A "HEPA" light indicates when the HEPA filter needs to be replaced.
The 'Odor' light indicates when the carbon filter needs to be replaced.
• The NanoCaptur filter contains translucent granules which change color according to the
formaldehyde absorption rate. Refer to the color chart on the inside of the panel or the filter itself
to establish the filter saturation rate.Once the saturation rate has reached its maximum, the filter
must be replaced. You have to check the filter saturation rate every six months.
• The pre-filter can be re-used: remove the dust using a vacuum cleaner or wash with water.
CAUTION:
• The appliance's efficiency can be reduced if the pre-filter is not cleaned regularly.
• Never use a pre-filter that is still damp.
• The pre-filter is the only filter which can be re-used and washed with water. The HEPA,
NanoCaptur and active carbon filters cannot be cleaned and re-used. Never wash with water.
• To replace the filters, follow the instructions in the section « Disassembling/Reassembling
filters ».
Your replacement filters are available under the following codes:
Filter
True HEPA Allergy+ filter
Active carbon filter
Nanocaptur filter
IMPORTANT: Resetting the filters
The reset light flashes when a filter needs to be replaced. Once the filter has been replaced, hold
down the reset button for 2 seconds.
10
Action
Clean
Replace
Replace
Replace
Code PU4020 mid. size
XD6074
XD6065
XD6085
.
Cycles
Every 2 to 4 weeks
Every 12 months
Every 2 years
Color changing
(see Color chart on filter)
Code PU6020 full size
XD6077
XD6066
XD6086