Tools Needed - Barrette Crossover product Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

GATE KIT INSTRUCTIONS
Warning: Always wear safety goggles.
Refer to local building codes for installation requirements; failure to install this product in
accordance with building codes may affect safety of the product and void product warranty.
Refer to manufacturers safety instructions when operating any tools.
All steps in these assembly instructions should be completed on a clean non-abrasive surface.
Steps and procedures in these assembly instructions assume the use of Boerboel
Wrap Hinges (sold separately: 73028117 for black hardware or 73025512 for white hardware).
If other hardware is being substituted, refer to those instructions.
COMPONENT LIST:
Check the kit to ensure all components are included:
A
C
B
D
NOTE: Standard width gate kits are 34.5" in width when built to fit a 36" opening with the
Boerboel Gate Hardware (sold separately.)
Custom width gates are manufactured 1.5" shorter than the opening (up to 49.5") to allow for
Boerboel Gate Hardware (sold separately). Custom width gates will have a different number of
balusters depending on the custom width specified.
2
A) Aluminum Top/Bottom
Frame Rail – 2
B) Vinyl Top/Bottom Frame Rail – 2
E
C) Aluminum Side Frame Rail – 2
F
D) Vinyl Side Frame Rail – 2
E) Assembly Screw – 16
G
F) Screw Head Cover – 16
G) Baluster – 5 for standard 36" width
®
Standard

TOOLS NEEDED:

– Safety goggles
– Tape measure
– Pencil
– Level
– Power screwdriver/drill
– Straight edge/ruler/triangle

Publicidad

Tabla de contenido
loading

Tabla de contenido