Ash Removal; Optional Extras - Jøtul I 400 Instrucciones Para Instalación

english
Option 2 – installed from inside (fig. 12 B):
1. First screw in halfway and diagonally 2 screws with washers
(fig. 13 A). Install the accompanying gasket on the top side
of the edge of the smoke bell in the gasket channel (fig. 12
B-1).
2. Move the smoke bell up inside the burn chamber so the smoke
bell notch is against the screws with washers (fig. 14 A).
3. Turn the smoke bell slightly so that it is resting on the screws
with washers (fig. 15 A).
4. Then screw in the two other screws (fig. 16 A) and then screw
all the screws almost all the way in.
5. Rotate the smoke bell to the desired position (fig. 17). Tighten
the screws.
6. Then install the flue pipe in the product's smoke bell. Use
gasket rope between the smoke bell and the flue pipe.
3.7 Checking the functions (fig. 4)
Once the product has been assembled, always check the control
handles. These must move easily, and work in a satisfactory
manner.
Jøtul I 400 is equipped with the following operating options:
Air vent fig. 4 A
Left position closed
Right position fully open
Lighting vent fig. 4 B
Left position Closed
Right position Fully open

3.8 Ash removal

1. Only remove ash when the stove is cold.
2. Always leave some ash there as a protective layer over the
bottom of the fireplace.
See also the description of how to handle ash in the General User
and Maintenance Instructions under point "6.1 Fire Prevention
Measures".
22
4.0 Servicing
Warning!
Any unauthorised changes to the product are illegal!
Only original spare parts may be used!
4.1 Replacing the baffle/exhaust deflector
(fig. 5)
NB! The burn plates are made of a porous material (yellow
vermiculite) and may be damaged if they are handled roughly.
1. Lift the baffle up on its side and ease it out (fig. 5 B).
2. Lift the exhaust deflector (fig. 5 A) up slightly, pull it right
back towards the rear wall and ease it out.
3. To replace the baffle and exhaust deflector, follow the same
procedure in reverse order.
4.2 Replacing the burn plates/air duct -
(figs. 4 and 5)
NB! The burn plates are made of a porous material (yellow
vermiculite) and may be damaged if they are handled roughly.
1. Lift the baffle up on its side and ease it out (fig. 5 B).
2. Remove the log retainer (fig. 4 C).
3. Then lift up the air duct (fig. 4 D) and take it out.
4. Take out the side burn plates (fig. 4 E) by tilting them out
back edge first.
5. Then remove the rear burn plate (fig. 4 E).
6. To install them, follow the same procedure in reverse order.

5.0 Optional extras

Ash solution -
Kit for outside
air connection -
Top and bottom grid, straight, BP - cat. no. 51012157
Top and bottom grid, curved, BP -
Side grid 65 mm, BP -
Side grid 115 mm, BP -
Low smoke bell -
Decorative frame, BP -
cat. no. 51012161
cat. no. 51012160
cat. no. 51043381
cat. no. 51012158
cat. no. 51012159
cat. no. 12019316
cat. no. 50043685