Maintenance - Senix GTSX5-M-0 Manual De Instrucciones

When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
Remove and pulling out the battery pack before
assembly! Wear protective gloves!
Maintain this product regularly and carefully! If the
product is improperly maintained, it may fail at its
intended task, which may produce fatal consequences.
1. Keep the product clean. Remove debris from it after
each use and before storage.
2. Regular and proper cleaning will help ensure safe
use and prolong the life of the product.
3. Inspect the product before each use for worn and
damaged parts.
Only perform repairs and maintenance work according
to these instructions! All further works must be
CLEANING
Remove battery when unattended, cleaning, servicing,
transporting, lifting, or stowing the unit.
Use only cloth, hand brush, etc. to clean the unit. Keep
all safety devices, air vents, and motor housing free of
debris and dirt.
To avoid serious personal injury, always stop the engine
and allow it to cool before cleaning or maintaining the
unit. Never perform cleaning or maintenance while the
unit is running. Remove the battery to prevent the unit
from starting accidentally.
1. If the battery is empty and the product is switched
off automatically, do not continue to press the On/Off
switch.
2. Charging the battery only after the battery pack has
cooled down.
3. Charging the battery completely if the product will not
be used for long time.
4. Charging the battery at least every 6 months to
maintain the optimal capacity.
12

MAINTENANCE

Never use metal-reinforced line, wire, chain or rope.
These can break off and become dangerous projectiles.
1. Remove the cutting line spool cover by pushing the
two release tabs. Remove the spool.
2. Remove any old line from the spool. Use a clean
cloth to clean the surface of the cutting head. Cut
a 16.4 ft. (5 m) length of 0.080 in. (2 mm) diameter
trimming line.
3. Bend the line at the midpoint and insert the bend into
the holding slot on the spool.
S
S
lding l t
WWW.SENIXTOOLS.COM