Pressure Switch Refit Procedure; Controls And Signals - ELMECO BLarge Manual De Uso

When the slush led cold drink led and led 1 blink on the electronic board at the same time, it indicates that the pressure
switch intervened to deactivate the compressor; In this condition the freezing will be OFF.
A too high temperature can be caused by:
1. Dirty filter; remove and clean the filter (pic.20 page 29);
2. The machine is located close to an heating source and its internal temperature increases;
3. The air circulation is obstructed.
In order to refit this device, it is important to follow the instructions below:
1. Remove the drip tray;
In case of two tanks machine remove the left drip tray.
2. Push the black button that is located at the center of the circular hole on the front panel;
3. The leds turn off indicating the successful operation of reset.
"slush" mode
functioning indicator;
"Cold drink" mode
functioning indicator.
Do not wash the membrane of the electronic control with abrasive substances or cloths.

Pressure switch refit procedure

Controls and signals

- 18 -
Start/stop augers switch;
Mode selector switch;
Product density indicator leds
(min 1, max 3);
Product cooling
activity indicator;