FS CD-200 Manual De Instalación página 7

CHANGING THE STROBE TUBE ASSEMBLY UNIT
WARNING: A serious injury may result if lamp is touched when hot. Always allow lamp
to cool before removing.
1) Remove and retain the four Nº8 screws which join the body to the lighthead lens.(See
figure 4, page 10).
2) Remove and retain the three Nº6 screws which fix the holder Nº7 to the lighthead
housing.
3) Unplug the connector.
4) Remove and retain the two screws which join the holder Nº7 to the reflector
5) Replace the strobe tube assembly unit, mounting the unit by following the dismounting
instructions in reverse. Please, be aware of the smooth face and the spreaded face position using
the reflector as a reference point. (See Fig. 4, page 10)
CAUTION: Service light of lamp will be shortened if glass portion is touched. If glass has
been handled, clean carefully with a pure alcohol.
6