Operation; Grounding Instructions - Pinnacle Products International Master SSR-822R-IHR Manual Del Usuario E Instrucciones De Operación

Operating The Heater:
Heater Controls
1. Plug power cord into 120V AC power outlet.
(See Grounding Methods)
2. Use pull cord to turn power to heater on
and off. The red light on the back cover will
illuminate indication power is on.
3. Once the power is on, use the push button on
the rear of the heater to control the heating
element and LED lights. (See Chart Below)
push button Control
Press 1 Time Heating element turns on.
Press 2 Times LED lights turn on.
Press 3 Times Heating element turns off
Press 4 Times LED lights turn off.
4. The remote control can also be used to
control the heating element and LED lights.
Direct the remote towards the sensor and
press buttons for desired function.
(See Chart Below)
Remote Control
left button
Press 1 Time
Press 2 Times LED lights turn off.
Right button
Press 1 Time Heating element turns on.
Press 2 Times Heating element turns off
© 2015, Pinnacle Products International, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE
CONNECTED TO A POWER SOURCE

Operation

LED lights turn on.

Grounding Instructions

SSR-822R-IHR / SSR-822G-IHR:
– This heater is for use on 120 Volts. The
cord has a plug as show at A (below). An
adapter as shown at C is available for
connecting three-blade grounding-type plugs
two-slot receptacles. The green grounding
lug extending from the adapter must be
connected to the permanent ground such as
a properly grounded outlet box. The adapter
should not be used if a three-slot grounded
receptacle is available.
Grounding Methods
Metal Screw
A
Figure 6
6 Halogen Infrared Heater User's Manual
C
Grounding Means
B
Grounding Pin