Publicidad
Idiomas disponibles
Idiomas disponibles
SLIDING DOOR HARDWARE - WALL-MOuNt
3
PREPARE DOOR
• Cut a 9/16" deep by 1/4" wide kerf along the
center of the bottom edge of the door for the
door guide.
• Locate quick release top mount plates on the top
edge of the door, 2-1/2" from the outside edge to
the center of the top plate. (1-3/32"to the closest
top mount plate edge.)
• Using the top mount plate as a template, pre-drill
3/32" diameter holes and secure with
(#8 x 1-1/2") screws.
4
HANG DOOR
• Open quick release latches on brackets.
• Slide door onto carrier screws and close latch.
• Adjust door alignment by rotating carrier adjustment
screw using provided wrench.
5
ADD StOPS
• Secure two stops on either side of the track at
both ends, flush with the track but not
protruding. This is to prevent the door from
going off the end of the track.
• For the two-door installation, install stops near
the center of the track to stop the doors in the
center of the opening.
2-1/2"
1-3/32"
Ref.
9/16"
#310374_A (0913)
Assembly
Instructions
2-1/2"
1/4"
Publicidad
