Publicidad
SLIDING DOOR HARDWARE - BI-FOLD
1
PREPARE OPENING
1/8" Min.
(0,3 cm)
1/16"
3/8"
(0,2 cm)
(1 cm)
Note: When using optional roller guide and bottom channel, use doorway height plus 3-1/2" when bottom guide channel is mounted
recessed, flush with finished floor. Use doorway height plus 4-1/8" if bottom guide channel is surface mounted.
2
MOUNT FRAME HARDWARE
• Using track as a template, mark
screw locations.
• IMPORTANT: Place track pivot and
hangers loose into track before
securing.
• Drill 3/32" pilot holes and secure
with (#8 x 1-1/2") screws.
• Locate top pivot bracket so center of
pivot slot is approximately 2-1/8"
from side jamb and hand tighten in place.
• Center bottom bracket directly below track
in jamb corner.
• Using floor plate as a template, drill
3/32" pilot holes and secure with
(#8 x 1-1/2") screws in slots only.
Note: When the finished opening is taller than max opening height, the floor plate may be fastened to a riser block
placed under the floor plate. The riser must be secured to the floor.
3
MOUNT DOOR HARDWARE
• Using top plates as a template, drill 3/32"
diameter holes and secure with (#8 x 1-1/2") screws*
so that the center of pivot is in locations shown.
• Using bottom plate as a template, drill 3/8"
clearanace hole 1-3/4" deep as shown and 3/32"
diameter holes and secure with (#8 x 1-1/2") screws.
• Thread bottom adjusting bolt into place.
• ATTACH HINGES. (purchased separately)
• ATTACH KNOB. (purchased separately)
*Note: Top carrier plate is mounted 1-1/4" from door edge for
2 and 4-doors. Plate is mounted 1-3/4" for multiple fold doors.
Multiple Fold Doors Width: Door Width + 9/16" (for pivot pair)
Hmax = Door Height + 5-1/4" • Hmin = Door Height + 3-7/16"
2-Door Width = 2 x Door Width + 9/16"
1/16"
(0,2 cm)
4-Door Width = 4 x Door Width + 1""
1/8" Gap Min.
(0,3 cm)
1-3/4"
(4,4 cm)
+ 3/8" (for each additonal pair)
3/8" Min.
(1 cm)
1/16"
(0,2 cm)
2-Door: Line up track flush against jamb on guide door side.
4-Door: Center track in opening.
1-3/4"
(4,4 cm)
1-3/4"
(4,4 cm)
Pivot
Guide
Pivote
Guía
#310297_D (0113)
Assembly
Instructions
Opening Height
Hauteur Ouverture
Altura Abertura
Door Height
Hauteur Porte
Altura Puerta
3/8"
(1 cm)
4-Door Only
4 portes seulement
Solo para 4 puertas
Pivot
Pivote
6"
(15,2 cm)
2-7/16" - 3-1/4"
(6,2 cm - 8,3 cm)
1" - 2"
(2,2 cm - 3,8 cm)
Centered
Centré
Centrado
Publicidad
