Cleaning & Maintenance; Troubleshooting - Bosch sensixx B35L Manual De Usario

en
Intelligent steam
(depending on the model)
This system has intelligent steam control, which,
after releasing the steam release button (15),
provides a small amount of additional steam.
The additional steam can always be stopped by briefly
pressing the steam release button once again.
Auto shutsoff
(depending on the model)
If during ironing the steam release button (15) on
the handle of the iron is not pressed for a certain
length of time (8 minutes), the steam station will
automatically switch off.
The "Auto shutboff" pilot lamp (4) will flash when
auto shutboff has been activated.
To switch the steam station back on, press the
steam release button again, and wait until the "Auto
shutboff" pilot lamp remains lit continuously.
Trouble shooting
Problem
The steam • There is a connection problem.
generator does not
come on. • The main power button is not switched
on.
The iron does not • The main power button is not switched
heat up. on.
• The temperature control knob is set to the
"min" position.
The iron begins • During first use: Certain components on
to smoke when the appliance have been lightly greased
switched on. at the factory and may produce a little
smoke when initially heated.
• During later use: the soleplate may be
soiled.
Water flows • The steam function is being used before it
through the holes has reached temperature.
on the sole plate. • The water is condensing inside the pipes
because steam is being used for the first
time or has not been used for a long time.
14
Cleaning & Maintenance
Always unplug the appliance from the mains
supply before carrying out any cleaning or
maintenance operation on it.
1. After ironing, pull out the plug and allow the
appliance to cool down before cleaning.
2. Wipe the housing, handle and iron body with a
damp cloth.
3. If the soleplate is soiled with dirt or scale, clean
it with a damp cloth.
4. Never use abrasive products or solvents.
Storing the appliance (E)
1. Always allow the appliance to cool down before
storing it.
2. Set the main power to the "0" position and
disconnect the mains cable.
3. Place the iron on the iron pad, standing on the
soleplate.
4. Empty the water tank and store the mains cable
on the cord rewind facility. Tidy the steam hose
on the handle of the iron using the cord clip
provided (12). Do not wrap the cords too tight.
Possible causes Solution
• Check the mains cable, the plug and
the socket.
• Set the main power button (8) to the
"I" position.
• Set the main power button (8) to the
"I" position.
• Set the temperature control knob (13)
to the desired position.
• This is completely normal and will
stop after a short while.
• Clean the soleplate according to the
cleaning instructions in this manual.
• Reduce the steam flow when ironing
at low temperatures (Variable steam
control (5)).
• Point the iron away from the ironing
area and press the steam release
button (15) until steam is produced.