Equipment Location; Electrical Connection - ERATOS DROP-IN Manual De Instalación, Uso Y Mantenimiento

INSTALLATION MANUAL
1.
WARNINGS
2.
TRANSPORT
3.
INSTALLATION

3.1. Equipment location

3.2. Water connection

3.3. Electrical connection

1. WARNINGS
Read this manual carefully before starting the installation.
To effect the installation correctly, take into account the following instructions:
 Do not alter the type plates or instructions attached by the manufacturer.
 Do not remove or alter the security elements.
 The equipment should not be operated in aggressive environments or with fire risk.
 Verify the equipment movable parts performance.
 Verify that the tension and mains frequency coincide with the ones indicated on the equipment type plate.
 Verify the control panel, electric wiring and connections integrity.
 Avoid the use of adaptors, extension cords or power strips.
 Perform the maintenance only by qualified staff.
 Only use spare parts supplied or approved by the manufacturer.
2. TRANSPORT
 Do not turn it upside down, but in case it is absolutely necessary, do it on the side indicated in the box.
 Unpack on solid, levelled and stable surface. In order to move it to the installation area, use a cart or
pallet forklift; do not drag along the floor.
 Unpack and unwrap it avoiding hitting and thus damaging the equipment.
 Verify there are no defects due to transportation. In case of defects caused during transportation, a claim
should be sent to the transportation company within the 24 hs subsequent to the equipment or material
reception.
3. INSTALLATION
3.1 Equipment location
It is a drop-in piece of equipment prepared to be installed as an independent item on any flat surface.
It is an article designed to perform in areas with room temperatures between 18º and 30ºC with a maximum
humidity of 55% HR (climatic class 4). If the temperature or humidity is higher, it may affect the equipment interior
temperature and cause malfunctioning or damage.
It is necessary that the upper part of the equipment is far from heating sources and that it has enough space
for a correct ventilation.
3.3 Electrical connection
It is essential that the electric installation has earth conductor, as well as a magneto-thermal protection cut-
out differential switch.
The supply network must have the proper section for the equipment consumption.
When the equipment is connected and working, the control panel warning light will be on.
If various pieces of equipment are installed, extension cords and multiple sockets should be avoided.
The manufacturer declines all responsibility in case of not complying with any of the previous items.
7
EN