GE PSB42 Manual Del Propietario E Instrucciones De Instalación página 22

STEP 7 LEVEL REFRIGERATOR
All models have 4-point leveling. The front is
supported by leveling legs, the rear is supported by
adjustable wheels. Both are accessible from the front
of the refrigerator.
hex nut located above the front wheels. Turn
clockwise to raise or
counterclockwise to lower
the refrigerator.
• Adjust height of
refrigerator to match
installation cutout opening
should be level and plumb with cabinetry.
NOTICE: The rear leveling wheels and front leveling
legs are limited to a maximum height adjustment
height, the installer should elevate the refrigerator
on a sheet of plywood or runners. Cabinetry trim
could also be added across the top of the opening
to shorten the opening. If you attempt to raise the
refrigerator more than 1", you will damage the
front leveling legs and the rear leveling wheels.
Make adjustments in small increments.
STEP 8 ALTERNATE ANTI-TIP
PROCEDURE
The refrigerator must be secured to prevent
tipping.
• Raise the grille panel to access case trim.
holes through the metal top case trim.
22
Installation Instructions
STEP 8 ALTERNATE ANTI-TIP
PROCEDURE (Cont.)
clearance holes and into the wood soffit. The holes
brace. The brace spanning the enclosure must be
securely fastened to cabinets on both sides.
trim.
STEP 9 ADJUST DOOR SWING
NOTE: This refrigerator has a 2-position door stop.
When space does not allow the door to swing open
fully to 115°, you may change the door swing to a
if door opening is satisfactory for your installation
situation.
• Open the door to view the bottom hinge.
Note the door stop pin locations. The pin is factory
installed in
the 115°
position.
• Close the
below, use
pliers to
unscrew the
door stop
and reinstall
position.
Door Trim Pinch Point
WARNING
Hazard
cabinets when operating the door, especially
follow the installation instructions for cabinet
dimensions, trim assembly, and door stop angle.
Skip this step
49-60742-4