Gladiator Garageworks GATC4110WG Instrucciones De Ensamblaje página 3

Maximum weight limit is 35 lbs (15.9 kg) for each of the 6.6"
■
(16.8 cm) wide drawers.
Maximum weight limit is 500 lbs (227.3 kg) for the tool chest.
■
The Gladiator ® Garageworks Premier 10 Drawer - 41" Tool Chest
■
is designed to be stacked on top of a Gladiator
12 Drawer - 41" Roll-Away, as shown on the cover.
Remove the tools from the drawers before stacking and
■
unstacking, and use two or more people to lift the tool
chests.
While using the tool chests, open only one drawer at a time
■
to avoid tipping.
Before moving the Roll-Away cabinet or Roll-Away cabinet
■
stacked with a tool chest to a different location, make sure all
the drawers are closed and locked. Use the push handle to
move the Roll-Away cabinet.
Unpack the Cabinet
NOTE: Keep the packing materials to cushion the cabinet during
assembly and then dispose of/recycle all packaging materials.
1. Locate the keys and unlock the door and drawers.
2. Verify contents. See "Parts Supplied."
Use, Remove and Replace the Drawers
NOTES:
Make sure all the drawers are fully closed before closing the lid.
■
The drawers will not open when the lid is closed.
The key locks the lid and all of the drawers.
■
Use the drawer liners to avoid scratching or damaging the
■
drawers.
Removing the Drawer
1. Unload the contents from the drawer.
2. Slide out the drawer as far as it will go.
3. Press the lever down on the right-hand track and lift the lever up
on the left track to release the drawer. Pull the drawer out the rest
of the way.
Replacing the Drawer
1. Align the drawer guides with the receiving glides.
2. Hold the receiving glides firmly and insert the drawer guide.
NOTE: It is normal for the drawer to close tightly the first time
after it has been removed.
3. Push the drawer in completely.
® Premier
A
A. Lever
Remove and Replace the Shelf
The shelf is supported by the metal loops on the side walls of the
cabinet. You can adjust the height of the shelf to accommodate your
storage needs.
1. Determine where you want to place the shelf.
2. Tilt the shelf so that one end is higher than the other as shown.
3. Insert the shelf into the cabinet so that the higher end is directly
above the desired slots and push the shelf down in place behind
the side slots.
B
A. Push down
B. Lift up
4. Raise the lower end so it is directly above the desired slots and
push the shelf down.
NOTE: Make sure the shelf tabs are in place behind all the slots,
as shown.
A. Slot
B. Shelf tab
A
A
B
3