RCA RSWW1 Guia De Instalacion página 9

Does the centering ring fit? If not, replace it!
The servo's centering ring should fit over the shut-off
valve's nut as shown here. If it doesn't, replace it with the
larger centering ring provided in the hardware kit.
1. Use the provided Allen wrench to remove the small
Nut
Allen-cap screw.
2. Remove the pre-installed (small) centering ring.
3. Install the larger centering ring. Then put the small
washer and Allen-cap screw back in place. Tighten
Centering ring
with the Allen wrench.
C. Close the brackets over the pipe
Insert (1) M5 x 30 x 0.8(mm) carriage bolt through each bracket as shown here.
(If these bolts are not long enough, use the M5 x 50 x 0.8(mm) ones instead.)
Place (1) washer, (1) spring washer, and (1) wing nut over each carriage bolt
and tighten just enough so that the servo stays mounted in place.
Centering ring
Small washer
Small Allen-
cap screw
Allen wrench
9